Deutsch
EnglishKeys and Remote Controls -> Remote Control for your Ford Ecosport 2012-2022
Keys and Remote Controls
Note: Changes or modifications not
PRINCIPLE OF OPERATION
The remote control allows you to:
expressively approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
The term IC before the radio certification
number only signifies that Industry Canada
technical specifications were met.
•
Remotely lock or unlock the vehicle
doors.
•
Unlock the doors without actively using
a key or remote control (intelligent
access only).
The typical operating range for your
transmitter is approximately 32.8 ft (10 m).
•
Activate the panic alarm.
A decrease in operating range could be
caused by:
Car Finder
•
•
•
•
weather conditions
nearby radio towers
structures around your vehicle
Press the button twice within
three seconds. The horn sounds
and the direction indicators
flash. We recommend you use this method
to locate your vehicle, rather than using
the panic alarm.
other vehicles parked next to your
vehicle.
The radio frequency used by your remote
control can also be used by other radio
transmitters, for example amateur radios,
medical equipment, wireless headphones,
wireless remote controls, cell phones,
battery chargers and alarm systems. If the
frequencies are jammed, you will not be
able to use your remote control. You can
lock and unlock the doors with the key.
Sounding the Panic Alarm
Note: The panic alarm only operates when
the ignition is off.
Press the button to sound the
panic alarm. Press the button
again or switch the ignition on to
turn it off.
Note: Make sure your vehicle is locked
before leaving it unattended.
GENERAL INFORMATION ON
RADIO FREQUENCIES
Note: If you are in range, the remote control
will operate if you press any button
unintentionally.
This device complies with Part 15 of the
FCC Rules and with Industry Canada
license-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) This device
must accept any interference received,
including interference that may cause
undesired operation.
Note: The remote control contains
sensitive electrical components. Exposure
to moisture or impact may cause permanent
damage.
REMOTE CONTROL
Remote Control With a Folding Key
Blade
Use the key blade to start your vehicle and
unlock or lock the driver door from outside
your vehicle. The transmitter portion
functions as the remote control.
51
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing
Keys and Remote Controls
Replacing the Battery
Note: Refer to local regulations when
disposing of transmitter batteries. Note: Do
not wipe off any grease on the battery
terminals or on the back surface of the
circuit board.
Note: Replacing the battery does not erase
the program med key from your vehicle. The
transmitter should operate normally.
4. Turn the remote control over to remove
the battery.
1. Insert a screwdriver as far as possible
into the slot on the side of the remote
control, gently push the clip.
2. Press the clip down to release the
battery cover.
Note: Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
5. Install a new battery (3V CR 2032) with
the + facing upwards.
6. Replace the battery cover.
3. Carefully remove the cover.
52
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing
Keys and Remote Controls
Remote Control
Intelligent Access Key (If Equipped)
Push the release button and pull the key
blade out.
The intelligent access keys operate the
power locks. The key must be in your
vehicle to use the push button start.
Replacing the Battery
Note: Refer to local regulations when
disposing of transmitter batteries.
Remove Key Blade
Note: Do not wipe off any grease on the
battery terminals or on the back surface of
the circuit board.
The intelligent access key also contains a
removable key blade that you can use to
unlock your vehicle.
Note: Replacing the battery does not erase
the program med key from your vehicle. The
transmitter should operate normally.
A message appears in the information
display when the remote control battery
is low. See Information Messages (page
96). See Information Messages (page ?).
The remote control uses one coin-type
three-volt lithium battery CR2450 or
equivalent.
53
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing
Keys and Remote Controls
1. Push the release button and pull the
key blade out.
2. Twist a thin coin under the tab hidden
behind the key blade head to remove
the battery cover.
54
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing
Keys and Remote Controls
3. Insert a suitable tool, for example a
screwdriver, in the position shown and
carefully remove the battery.
4. Install a new battery with the + facing
upward.
5. Reinstall the battery cover and the key
blade.
REPLACING A LOST KEY OR
REMOTE CONTROL
Replacement keys or remote controls can
be purchased from an authorized dealer.
Authorized dealers can program remote
controls for your vehicle. See Passive
Anti-Theft System (page 67).
55
EcoSport (CBW) Canada/United States of America, Vehicles Built From: 17-06-2019, LN1J-19A321-ZFA enUSA, Edition date: 201904, First-Printing
