Deutsch
EnglishMaintenance -> Changing the Rear Wiper Blades for your Ford Focus 2018-2025
Maintenance
If you disconnect or replace the vehicle
CHANGINGTHEFRONTWIPER
BLADES
1. Fully lift the wiper arm.
battery, you must reset the following
features:
•
Window bounce-back. See Resetting
Window Bounce-Back (page 127).
Note: Do not hold the wiper blade to lift the
•
•
Clock Settings.
wiper arm.
Pre-set radio stations.
Battery Disposal
Make sure that you dispose of
old batteries in an
environmentally friendly way.
Seek advice from your local authority
about recycling old batteries.
E264374
2. Press the wiper blade locking button.
WASHER FLUID CHECK
When adding fluid, use a mixture of washer
fluid and water to help prevent freezing
and improve the cleaning capability. For
information on fluid dilution follow the
manufacturer's instructions.
Note: The reservoir supplies the front and
rear washer systems.
E264375
CHECKING THE WIPER
BLADES
3. Remove the wiper blade.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
4. To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.
CHANGING THE REAR WIPER
BLADES
1. Lift the wiper arm.
E142463
Run the tip of your fingers over the edge of
the blade to check for roughness.
Note: Do not hold the wiper blade to lift the
Clean the wiper blades with washer fluid
or water applied with a soft sponge or
cloth.
wiper arm.
430
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing
Maintenance
2
1
2
E264496
1. Use a suitable tool, for example a small
flat blade screwdriver, to carefully raise
the center pin and then remove the trim
clip.
E183236
2. Disengage the wiper blade from the
wiper arm.
Note: Make sure that the wiper arm does
not spring back against the glass when the
wiper blade is not attached.
2. Remove the screws that secure the
lamp assembly.
3. To install, reverse the removal
procedure.
Note: Make sure that the wiper blade locks
into place.
E249609
REMOVING A HEADLAMP
3. Carefully lift the rear of the headlamp
up to disengage it from the lower fixing
point.
WARNING: Switch the lamps and
the ignition off. Failure to do so could
result in serious personal injury.
4. Remove the headlamp.
Note: Take care when removing the lamp.
There are rupture points adjacent to the
headlamp securing screws that are designed
to separate under impact.
WARNING: Lamps and associated
components become hot when in use.
Let them cool down before you remove
them.
5. Disconnect the electrical connector.
6. To install, reverse the removal
procedure.
431
Focus (CGE) Vehicles Built From: 15-03-2021, CG3784en enGBR, Edition date: 202012, First-Printing
