Deutsch
EnglishLighting -> Front Fog Lamps for your Ford Kuga 2019-2025
Lighting
The system is designed to turn the high
beams on if all of the following occur:
Switching Glare-Free High Beam
On or Off
•
•
•
•
•
You switch the system on through your
You can switch the system on or off
vehicle settings.
through your vehicle settings.
You set the lighting control to the
autolamps position.
Depending on your vehicle options, the
vehicle settings may be in the following:
The ambient light level is low enough
•
Information display. See General
that high beams are required.
Information (page 110).
There is no traffic in front of your
vehicle.
•
Touchscreen. See Settings (page 462).
Note: The lighting control defaults to
autolamps each time you switch your
vehicle on.
Your vehicle speed is greater than
approximately 40 km/h (25 mph).
The system is designed to adapt the high
beams to avoid glare if all of the following
occur:
Glare-Free High Beam Indicator
It illuminates to confirm when
•
•
•
You switch the system on through your
the system is ready to assist.
vehicle settings.
You set the lighting control to the
autolamps position.
Overriding Glare-Free High Beam
The system detects an approaching
Push the lever away from you to switch
vehicle's headlamps or rear lamps.
between high beam and low beam.
The high beam headlamp
indicator remains on when the
system adapts the high beams
FRONT FOG LAMPS(IF EQUIPPED)
to avoid glare.
SwitchingtheFrontFogLampsOn
or Off
The system is designed to turn the high
beams off if any of the following occur:
Only switch the front fog lamps on during
reduced visibility.
•
You switch the system off through your
vehicle settings.
You can switch the front fog lamps on if
•
You set the lighting control to any
position except autolamps.
any of the following occur:
•
•
•
You set the lighting control to the
parking lamps position.
•
•
You switch the rear fog lamps on.
The system detects severe rain, snow
You set the lighting control to the
or fog.
headlamps position.
•
•
•
The system detects street lighting.
The camera has reduced visibility.
You set the lighting control to the
autolamps position and the headlamps
are on.
Your vehicle speed falls below
approximately 30 km/h (19 mph).
The front fog lamp button is on the lighting
control.
Note: The deactivation speed is lower on
curves.
82
Kuga (CTD) Vehicles Built From: 22-06-2021, CG3851en enGBR, Edition date: 202104, First-Printing
Lighting
Press the button to switch the
HEADLAMP LEVELING -
VEHICLES WITH: AUTOMATIC
HEADLAMP LEVELING
This vehicle is equipped with a dynamic
automatic leveling system. The headlamps
do not require additional aim adjustment.
front fog lamps on or off.
Note: The brightness of the daytime running
lamps may decrease when the front fog
lamps are switched on.
Front Fog Lamp Indicator
It illuminates when you switch
the front fog lamps on.
HEADLAMP LEVELING -
VEHICLES WITH: MANUAL
HEADLAMP LEVELING
REAR FOG LAMPS
Switching the Rear Fog Lamps On
To adjust the level of the headlamp
beams, do the following:
or Off
WARNING: Do not use the rear fog
lamps when it is raining or snowing and
visibility is more than 50 m (164.0 ft).
You can switch the rear fog lamps on if any
of the following occur:
•
•
You switched the front fog lamps on.
You set the lighting control to the
headlamps position.
E298104
•
You set the lighting control to the
autolamps position and the headlamps
are on.
Rotate the control in accordance with your
vehicle load to prevent you from distracting
other road users when the headlamps are
on.
The rear fog lamp button is on the lighting
control.
Note: Set the control to zero when your
Press the button to switch the
vehicle is unloaded.
rear fog lamps on or off.
Note: Set the headlamp beams to give
between 35–100 m (115–328 ft) of road
surface illumination when your vehicle is
partially or fully loaded.
Rear Fog Lamp Indicator
It illuminates when you switch
the rear fog lamps on.
83
Kuga (CTD) Vehicles Built From: 22-06-2021, CG3851en enGBR, Edition date: 202104, First-Printing
