Deutsch
EnglishEase of use and comfort -> Rear fittings for your Peugeot 3008 2016-2023
Ease of use and comfort
In "Permanent lighting" mode, the lighting time
varies according to the circumstances:
– With the ignition off, approximately 10 minutes.
– In energy saving mode, approximately 30
seconds.
Rear fittings
12 V accessory socket
– With the engine running, unlimited.
When the front courtesy lamp is in the
"Permanent lighting" position, the rear
courtesy lamp also comes on, unless it is in
the "Permanently off" position.
To switch off the rear courtesy lamp, put it in
the "Permanently off" position.
3. Rear courtesy lamp
4. Rear reading lamps
► To connect a 12 V accessory (maximum
power: 120 W), lift the cover and plug in a
suitable adaptor.
Reading lamps
Front and rear courtesy
lamps
► With the ignition on, operate the
The connection of an electrical device
not approved by PEUGEOT, such as a
USB charger, may adversely affect the
operation of vehicle electrical systems,
causing faults such as poor radio reception or
interference with displays in the screens.
corresponding switch.
In this position, the courtesy lamp comes
on gradually:
Do not place anything against the
courtesy lamps.
– when the vehicle is unlocked.
– when the key is removed from the ignition
switch.
– when a door is opened.
Interior ambient lighting
– when the remote control locking button is
activated, in order to locate the vehicle.
It switches off gradually:
– when the vehicle is locked.
– when the ignition is switched on.
– 30 seconds after the last door is closed.
Permanently off.
The dimmed passenger compartment lighting
improves visibility in the vehicle when the light
is poor.
At night, the ambient lighting comes on/goes off
automatically when the sidelamps are switched
on/off.
Activation / deactivation and adjustment
of the light intensity are set via the
Driving / Vehicle touch screen menu.
Permanent lighting.
66
Ease of use and comfort
The armrest incorporates two cup holders.
USB sockets
"Aircraft" type tables
3
Ski flap
Device for storing and transporting long objects.
Opening
► With the rear armrest lowered, open the flap
by pulling its handle downwards.
Each USB socket is used only to power or
recharge a portable device.
Rear armrest
► To use the table, lower it fully until it locks in
the low position.
► To store it, raise the table to the high position,
passing the point of resistance.
On the passenger side, do not forget to
fold it before placing the backrest in the
"table" position.
For more information on the Front seats, and
in particular placing the backrest in the "table"
position, refer to the corresponding section.
► Load the objects from inside the boot.
Do not place hard or heavy objects on
the table.
They could become dangerous projectiles in
the event of emergency braking or impact.
67
Ease of use and comfort
Side blinds
2. 12V accessory socket (max. 120W)
3. Boot lamp
4. Rear seat folding controls
5. Hooks
6. Stowing rings
7. Boot floor
8. Storage well/Tool box under the floor
9. Open storage compartments
Depending on version, the storage boxes are
fitted in the floor, at the foot of the side seats on
the second row.
On the left-hand side, it may also contain the
temporary puncture repair kit.
► To open them, lift the cover by the notch.
Boot fittings
Fitted to the second row windows, they protect
the passenger compartment from the sun's rays.
► Pull the central tab to unroll the blind.
► Position the blind's clip on the hook.
Always guide the blind slowly, using the
tab, while raising or lowering it.
1. Load space cover roller
2. 12 V accessory socket (max. 120 W)
3. Boot lamp
Storage boxes
4. Luggage retaining strap
5. Storage brackets of the load space cover
roller
6. Armrest with cup holder and storage
compartment
7. Open storage compartment
1. Load space cover shelf
68
