Deutsch
EnglishPractical information -> Motorhazteto for your Peugeot 3008 2016-2023
Practical information
If a telephone call is in progress at the
time, it will be maintained for around 10
minutes via the audio system’s hands-free
system.
functions, such as the air conditioning and the
heated rear screen.
The deactivated functions are reactivated
automatically as soon as conditions permit.
opened when the left-hand front door is
closed.
7
When the engine is hot, handle the
exterior safety catch and the bonnet stay
with care (risk of burns), using the protected
area.
When the bonnet is open, take care not to
damage the safety catch.
Motorháztető
Exiting the mode
These functions are automatically reactivated the
next time the vehicle is used.
Stop & Start
Before doing anything under the bonnet,
you must switch off the ignition to avoid any
risk of injury resulting from an automatic
change to START mode.
To restore the use of these functions
Do not open the bonnet under very windy
conditions.
immediately, start the engine and let it run:
– For less than 10 minutes, to use the
equipment for approximately 5 minutes.
– For more than 10 minutes, to use the
equipment for approximately 30 minutes.
Let the engine run for the specified duration to
ensure that the battery charge is sufficient.
To recharge the battery, avoid repeatedly or
continuously restarting the engine.
Cooling of the engine when stopped
The engine cooling fan may start after
the engine has been switched off.
Take care with objects or clothing that
could be caught in the blades of the fan!
Rechargeable hybrid vehicles
Before any work is carried out under the
bonnet, it is essential to switch off the ignition
and disconnect the charging connector nozzle
if it is connected, check that the READY
indicator lamp is off on the instrument panel
and wait 4 minutes - risk of serious injury!
Opening
A flat battery prevents the engine from
starting.
For more information on the 12 V battery,
refer to the corresponding section.
Load reduction mode
This system manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates certain
The location of the interior bonnet
release lever prevents the bonnet being
► Open the left-hand front door.
179
Practical information
► Pull the interior release lever, located at the
bottom of the door frame, towards you.
Petrol engine
Closing
► Hold the bonnet and pull out the stay from the
support slot.
► Clip the stay in its housing.
► Lower the bonnet and release it near the end
of its travel.
► Pull on the bonnet to check that it is locked
correctly.
Because of the presence of electrical
equipment under the bonnet, it is strongly
recommended that exposure to water (rain,
washing, etc.) be limited.
Diesel engine
► Lift the exterior safety catch and raise the
bonnet.
Engine compartment
The engine shown here is an example for
illustrative purposes only.
The locations of the following elements may
vary:
1. Screenwash fluid reservoir
2. Engine coolant reservoir
3. Brake fluid reservoir
4. Battery/Fuses
5. Remote earth point (-)
6. Fusebox
– Air filter.
– Engine oil dipstick.
– Engine oil filler cap.
– Priming pump.
7. Air filter
– Degassing screw.
8. Engine oil filler cap
9. Engine oil dipstick
10. Priming pump*
► Unclip the stay from its housing and place it
in the support slot to hold the bonnet open.
11. Degassing screw*
* Depending on engine.
180
