Deutsch
EnglishPractical information -> Snow chains for your Peugeot 3008 2016-2023
Practical information
These points are concealed by the vehicle doors
when the doors are closed.
The roof bar fixings have a stud which must be
inserted into the opening of each fixing point.
Remove the roof bars once they are no longer
needed.
Original tyre size
Maximum link size
7
235/50 R19
Not suitable for
chains
Sunroof
Check that the load does not pass below
the roof bars so that it does not impede the
movements of the sunroof - risk of major
damage!
Maximum load distributed over the
transverse roof bars, for a loading height
not exceeding 40 cm (except bicycle carrier):
80 kg.
As this value may change, please verify the
maximum load quoted in the guide supplied
with the roof bars.
If the height exceeds 40 cm, adapt the speed
of the vehicle to the profile of the road to
avoid damaging the roof bars and the fixings
on the vehicle.
Be sure to refer to national legislation in order
to comply with the regulations for transporting
objects that are longer than the vehicle.
For more information on snow chains, contact a
PEUGEOT dealer or a qualified workshop.
Installation tips
► To fit the snow chains during a journey, stop
the vehicle on a flat surface at the side of the
road.
► Apply the parking brake and position any
wheel chocks under the wheels to prevent
movement of the vehicle.
► Fit the snow chains following the instructions
provided by the manufacturer.
► Move off gently and drive for a few moments,
without exceeding 31 mph (50 km/h).
► Stop the vehicle and check that the snow
chains are correctly tightened.
Snow chains
In wintry conditions, snow chains improve
traction as well as the behaviour of the vehicle
when braking.
Snow chains must be fitted only to the
front wheels. They must never be fitted to
"space-saver" type spare wheels.
Observe the legislation in force in your
country relating to the use of snow
chains and maximum authorised speeds.
Recommendations
Distribute the load uniformly, taking care
to avoid overloading one of the sides.
Arrange the heaviest part of the load as close
as possible to the roof.
It is strongly recommended that you
practise fitting the snow chains on a level
and dry surface before setting off.
Use only chains designed to be fitted to the type
of wheel fitted to the vehicle:
Secure the load firmly.
Avoid driving with snow chains on roads
that have been cleared of snow to avoid
damaging the vehicle's tyres and the road
surface. If the vehicle is fitted with alloy
wheels, check that no part of the chain or its
fixings is in contact with the wheel rim.
Original tyre size
215/65 R17
Maximum link size
Drive gently: the vehicle will be more
susceptible to the effects of side winds and its
stability may be affected.
Regularly check the security and tight
fastening of the roof bars, at least before each
trip.
9 mm
9 mm
9 mm
225/55 R18
205/55 R19
177
Practical information
Rechargeable hybrid vehicles
The use of snow chains is only
authorised on the front wheels.
Before any operation, ensure that the
engine is off and the cooling fan has
stopped.
Removing
The driving mode selector must be on the
4WD position (depending on version).
It is essential to remove them when:
– the outside temperature exceeds
10°C.
Very cold climate screen
(Depending on country of sale)
This removable device prevents the
accumulation of snow around the radiator
cooling fan.
– recovery is in progress.
– the speed is above 75 mph (120 km/h).
Fitting
► Insert a finger into the notch in the upper part
of the screen.
► Pull towards you to unclip the unit.
Repeat these operations for the other screen.
It consists of two elements to be attached to the
front bumper.
Energy economy mode
This system manages the duration of use of
certain functions, in order to conserve a sufficient
level of charge in the battery with the ignition off.
After switching off the engine and for a maximum
cumulative period of around 30 minutes, you can
continue to use functions such as the audio and
telematics system, dipped beam headlamps or
courtesy lamps.
► Hold the corresponding screen in front of the
lower grille of the bumper.
► First insert the upper and side fixing brackets
into the bumper.
► Tilt the screen downwards to engage the
lower part of the screen into the bumper.
► Check that the unit is firmly held by pressing
around the edges.
In case of difficulty with installation/
removal
Contact a PEUGEOT dealer or a qualified
workshop.
Selecting the mode
A confirmation message is displayed when
energy economy mode is entered, and the active
functions are placed on standby.
Repeat these operations for the other screen.
178
