Keys and Remote Controls -> Remote Control-Vehicles With-Keyless Entry for your Ford Fiesta 2017-2023
Keys and Remote Controls
GENERAL INFORMATION ON
REMOTECONTROL-VEHICLES
WITH: KEYLESS ENTRY
RADIO FREQUENCIES
Note: Changes or modifications not
expressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
Passive Key
The typical operating range for your
transmitter is approximately 10 m (33 ft).
A decrease in operating range could be
caused by:
•
•
•
•
weather conditions
nearby radio towers
structures around your vehicle
other vehicles parked next to your
E266840
vehicle.
The key must be in your vehicle to switch
the ignition on and start the engine.
The radio frequency used by your remote
control can also be used by other radio
transmitters, for example amateur radios,
medical equipment, wireless headphones,
wireless remote controls, cell phones,
battery chargers and alarm systems. If the
frequencies are jammed, you will not be
able to use your remote control. You can
lock and unlock the doors with the key.
Removable Key Blade
The passive key also contains a removable
key blade that you can use to unlock your
vehicle.
2
Note: Make sure your vehicle is locked
before leaving it unattended.
Note: If you are in range, the remote control
will operate if you press any button
unintentionally.
Note: The remote control contains sensitive
electrical components. Exposure to moisture
or impact may cause permanent damage.
1
1
E87964
39
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Keys and Remote Controls
1. Press and hold the buttons on the
edges of the transmitter to release the
cover. Carefully remove the cover.
2
2. Remove the key blade from the
transmitter.
Changing the Remote Control
Battery
1
WARNING: Keep batteries away
from children to prevent ingestion.
Failure to follow this instruction could
result in personal injury or death. If
ingested, immediately seek medical
attention.
1
E87964
WARNING: If the battery
compartment does not securely close,
stop using the remote control and
replace it as soon as possible. In the
meantime, keep the remote control away
from children. Failure to follow this
instruction could result in personal injury
or death.
1. Press and hold the buttons on the
edges of the transmitter to release the
cover. Carefully remove the cover.
2. Remove the key blade from the
transmitter.
Make sure that you dispose of
old batteries in an
3
environmentally friendly way.
Seek advice from your local authority
about recycling old batteries.
The remote control uses one coin-type
three-volt lithium battery CR2032 or
equivalent.
E105362
3. Use a suitable tool, for example a
screwdriver, to carefully separate the
two halves of the remote control.
40
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Keys and Remote Controls
5. Carefully remove the battery with the
screwdriver.
Note: Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
6. Insert a new battery with the + facing
downward.
Note: Do not wipe off any grease on the
battery terminals or on the back surface of
the circuit board.
7. Assemble the two halves of the remote
4
control.
8. Reinstall the key blade.
E119190
Locating Your Vehicle
Press the lock button on the key twice
within three seconds. The direction
indicators will flash.
4. Twist the screwdriver in the position
shown to separate the two halves of
the remote control.
5
E125860
Remote Control Information Messages
Message
Action
Key battery low Replace Displays when the remote control battery requires replacing.
soon
41
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing





