Deutsch
EnglishRoadside Emergencies -> Jump Starting the Vehicle for your Ford Fiesta 2017-2023
Roadside Emergencies
Note: When you try to restart your vehicle
To Connect the Booster Cables
after a fuel shutoff, the vehicle makes sure
that various systems are safe to restart.
Once your vehicle determines that the
systems are safe, then the vehicle will allow
you to restart.
Note: In the event that your vehicle does
not restart after your third attempt, contact
an authorized dealer.
A
JUMPSTARTINGTHEVEHICLE
C
D
WARNING: Do not use fuel lines,
engine valve covers, windshield wiper
arms, the intake manifold, or hood latch
as ground points.
WARNING: Connect batteries with
only the same nominal voltage.
B
WARNING: Use only adequately
sized cables with insulated clamps.
Note: Do not disconnect the battery from
your vehicle’s electrical system.
E102925
A
B
C
D
Vehicle with low charge battery
Booster battery vehicle
Positive connection cable
Negative connection cable
1. Position the vehicles so that they do
not touch one another.
2. Switch off the engine and any electrical
equipment.
3. Connect the positive (+) terminal of
vehicle B with the positive (+) terminal
of vehicle A (cable C).
223
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
Roadside Emergencies
TOWING POINTS -
EXCLUDING: ST
Front Towing Point
WARNING: Make sure that the
towing eye is fully tightened. Failure to
follow this instruction could result in
personal injury.
E270780
WARNING: You must switch the
ignition on when your vehicle is being
towed.
4. Connect the negative (-) terminal of
vehicle B to the ground connection of
vehicle A (cable D).
WARNING: Do not connect the
negative (-) cable to the negative (-)
terminal of the discharged battery.
WARNING: Make sure that the
cables are clear of any moving parts and
fuel delivery system parts.
1
To Start the Engine
1. Run the engine of vehicle B at a
moderately high speed.
2. Start the engine of vehicle A.
E292787
3. Run both vehicles for a minimum of
three minutes before disconnecting the
cables. Do not switch on the
1. Push the cover.
2. Carefully remove the cover.
headlamps when disconnecting the
cables. The peak voltage could blow
the bulbs.
Disconnect the cables in the reverse order.
224
Fiesta (CE1) Vehicles Built From: 06-01-2020 Vehicles Built Up To: 19-04-2020, CG3654en enGBR, Edition date: 201909, Second-Printing
