Driving -> Parking sensors for your Peugeot 3008 2016-2023
Driving
(white: more distant, orange: close, red: very
The system signals the presence of obstacles
within the sensors’ detection zone.
The proximity information is given by an
intermittent audible signal, the frequency of
which increases as the vehicle approaches the
obstacle.
When the distance between the vehicle and
the obstacle becomes less than about thirty
centimetres, the audible signal becomes
continuous.
Parking sensors
6
close).
When the obstacle is very close, the "Danger"
symbol is displayed on the screen.
For more information, refer to the
General recommendations on the use
of driving and manoeuvring aids.
Front parking sensors
Supplementing the rear parking sensors, the
front parking sensors are triggered when an
obstacle is detected in front and the speed of the
vehicle is below 6 mph (10 km/h).
The sound emitted by the speaker (right or
left) indicates the side on which the obstacle is
located.
Front parking sensor operation is suspended if
the vehicle stops for more than three seconds in
forward gear, if an obstacle is no longer detected
or the vehicle speed exceeds 6 mph (10 km/h).
This system detects and signals the proximity of
obstacles (e.g. pedestrian, vehicle, tree, barrier)
using sensors located in the bumper.
Adjusting the audible signal
Depending on version, with
The sound emitted by the speaker (front
or rear) locates the obstacle relative to
the vehicle, whether in front of or behind it on
its path.
PEUGEOT Connect Radio or
PEUGEOT Connect Nav, pressing this button
opens the window for adjusting the volume of
the audible signal.
Rear parking sensors
► Engage reverse gear to start the system
(confirmed by an audible signal).
The system is switched off when reverse gear is
disengaged.
Deactivation/Activation
Visual assistance
The settings are changed via
the Driving/Vehicle touch screen menu.
The system status is memorised when the
ignition is switched off.
Audible assistance
The rear parking sensors system will be
deactivated automatically if a trailer or
bicycle carrier is connected to a towing device
installed in accordance with the
This supplements the audible signal by
manufacturer's recommendations.
displaying bars on the screen that represent the
distance between the obstacle and the vehicle
153
Driving
The parking sensors are deactivated while the
Park Assist function is measuring a space.
For more information on the Park
Assist function, refer to the corresponding
section.
The parking sensors supplement the information
on the view from above the vehicle.
Various contextual views may be displayed:
– Standard view.
– 180° view.
– Zoom view.
Operating limits
AUTO mode is activated by default.
In this mode, the system chooses the best
view to display (standard or zoom).
You can change the type of view at any time
during a manoeuvre.
► Press the button in the bottom left-hand
corner of the touch screen.
► Select the type of view:
• "Standard view".
If the boot is heavily loaded, the vehicle may tilt,
affecting distance measurements.
Malfunction
With the engine running, these systems allow
views of your vehicle’s close surroundings to be
displayed on the touch screen using one camera
for Visiopark 1 and two cameras for Visiopark 2.
In the event of a malfunction when
changing into reverse gear, this warning
lamp lights up on the instrument panel,
accompanied by the display of a message and
an audible signal (short beep).
• "180° view".
• "Zoom view".
• "AUTO view".
Have it checked by a PEUGEOT dealer or a
qualified workshop.
The display is immediately updated with the type
of view selected.
The system status is not saved when the ignition
is switched off.
Visiopark 1 - Visiopark 2
For more information, refer to the
General recommendations on the use
of driving and manoeuvring aids.
Operating principle
The screen is divided into two parts with a
contextual view and a view from above the
vehicle in its close surroundings.
154





