Deutsch
EnglishIn the event of a breakdown -> Tool kit for your Peugeot 3008 2016-2023
In the event of a breakdown
2.0 HDi engines
With temporary puncture repair kit
► Open the bonnet and then, if necessary,
unclip the cover to access the priming pump.
► Loosen the degassing bolt.
► Operate the priming pump until fuel
appears in the transparent tube.
► Retighten the degassing bolt.
► Operate the starter motor until the engine
starts (if the engine does not start at the first
attempt, wait around 15 seconds before trying
again).
► If the engine does not start after a few
attempts, operate the priming pump again, then
the starter motor.
► Unclip the two fixings to open its cover.
► Put the cover back in place and clip it in, then
close the bonnet.
With spare wheel
The tool kit is stored in the boot, under the floor.
To access it:
Versions with 2-position boot floor:
► Open the boot.
► Place the adjustable boot floor in the high
position.
► Lift the boot floor past the two retractable
stops.
Tool kit
Set of tools supplied with the vehicle.
Its content depends on your vehicle's equipment:
– Temporary puncture repair kit.
– Spare wheel.
► Place the boot floor onto these two stops to
hold it up.
Accessing the tools
Versions with articulated boot mat
(Rechargeable hybrid):
► Open the boot.
► Unfold the articulated boot mat by pulling its
handle until it is fully opened.
► Unclip the storage box by pulling it upwards.
► Unclip the two fixings to open its cover.
190
In the event of a breakdown
With temporary puncture repair kit
The tool box is installed at the centre of the
spare wheel beneath the vehicle.
It contains the jack and the wheel bolt cover
removal tool.
Accessing the tools
8
► First, access the spare wheel.
For further information on the Spare wheel,
please refer to the corresponding section.
► Press the tab to unlock the cover.
► While keeping the tab pressed in, slide the
cover to the middle and remove it.
Model without storage box
This kit, stored in a bag, is installed behind the
second row left-hand seat.
► Fold the seat backrest onto the cushion to
access the bag.
List of tools
Some of the tools are stored beneath the floor
against the boot sill.
The left-hand box contains the wheelbrace and
its extension piece.
Model with storage box
The right-hand box contains the wheel chocks
and the towing eye.
To access it:
This kit is installed in the storage box, located in
front of the second row left-hand seat.
► Open the storage box cover to access the kit.
► Open the boot.
With spare wheel
► Fold the concertina panels.
► Install the third row seats.
► Unclip the required tools from the boot sill
trim.
1. Chocks to immobilise the vehicle (depending
on equipment)
2. Socket for the wheel security bolts (located in
the glove box) (depending on equipment)
To adapt the wheelbrace to the special
‘security’ bolts.
3. Removable towing eye
191
In the event of a breakdown
For more information on Towing the vehicle
and using the removable towing eye, refer to the
corresponding section.
With spare wheel
These tools are specific to the vehicle
and may vary according to the level of
equipment.
Do not use them for any other purpose.
With temporary puncture repair kit
Kit 1
The jack must only be used to change a
wheel with a damaged or punctured tyre.
Do not use any jack other than the one
supplied with the vehicle.
If the vehicle does not have its original jack,
contact a PEUGEOT dealer or a qualified
workshop to obtain the one that was intended
by the manufacturer.
The jack meets European standards, as
defined in the Machinery Directive 2006/42/
CE.
5. Wheelbrace
Kit 2
For removing the wheel trim and the wheel
bolts.
6. Jack with integrated handle
The jack does not require any maintenance.
To raise the vehicle.
7. Wheel bolt cap removal tool (depending on
Temporary puncture
repair kit
equipment)
For removing the wheel bolt head finishers on
alloy wheels.
8.
Scan the QR Code on page 3 to view
explanatory videos.
4. 12 V compressor with cartridge of sealant
and speed limit sticker
Made up of a compressor and a sealant
cartridge, it allows you to carry out a temporary
repair of the tyre so that you can drive to the
nearest garage.
Wheelbrace extension
For loosening/tightening the spare wheel
carrier winch cable nut.
For temporary repair of a tyre and to adjust
the tyre pressure.
It is designed to repair most punctures located
on the tyre tread.
For more information on the Spare wheel, refer
to the corresponding section.
For more information about the Temporary
puncture repair kit, refer to the corresponding
section.
192
