Deutsch
EnglishLighting and visibility -> Static cornering lighting for your Peugeot 3008 2016-2023
Lighting and visibility
With the ring of the lighting control stalk in the
"AUTO" position and the function activated on
the touch screen, this system automatically
switches between dipped and main beam
headlamps, according to lighting and traffic
conditions, using a camera located at the top of
the windscreen.
► Switch the headlamps manually between
dipped and main beam to pause the function.
If the "AUTO" and "Dipped beam" indicator
lamps were on, the system changes to main
beam.
If the "AUTO" and "Main beam" indicator lamps
were on, the system changes to dipped beam.
► To reactivate the function, once again switch
the headlamps manually between dipped and
main beam.
Activation/Deactivation
It is set via the Driving / Vehicle touch
screen menu.
The state of the system stays in the memory
when switching off the ignition.
Operation
If the ambient light level is very low and traffic
conditions permit:
– The main beam headlamps
come on automatically. These
indicator lamps light up on the instrument panel. Static cornering lighting
If the ambient light level is sufficient and/or the
traffic conditions do not allow the main beam
headlamps to be lit:
– The dipped beam headlamps
remain lit. These indicator lamps
light up on the instrument panel.
The function is deactivated if the foglamps
are switched on or if the system detects poor
visibility conditions (e.g. fog, heavy rain,
snowfall).
This system is a driving aid.
The driver remains responsible for
the vehicle's lighting, its correct use in the
prevailing light, visibility and traffic conditions,
and for compliance with driving and vehicle
regulations.
When the foglamps are switched off or when the
With the dipped or main beam headlamps on,
this function allows headlamps to illuminate
the inside of a bend using light-emitting diodes
(LEDs).
The speed of the vehicle must be less than 56
mph (90 km/h).
visibility conditions become favourable again, the
function is automatically reactivated.
This indicator lamp goes out when the
function is deactivated.
The system becomes operational when
the vehicle exceeds 16 mph (25 km/h).
When the speed falls below 9 mph (15 km/h),
the function is no longer operational.
Pause
This function is only available with the "Full LED"
technology headlamps.
If the situation requires a change of headlamp
beam, the driver can take over at any time.
78
Lighting and visibility
not available (in "Night Vision" mode), the
conditions are met, an alert is triggered if there is
a risk of collision.
The permanent display disappears upon
switching off the ignition or if the conditions are
not met.
Activation / Deactivation
4
indicator lamp comes on in grey.
It is set via the Driving / Vehicle touch
If all operating conditions are met, the
indicator lamp comes on in green: the
display in the instrument panel (with "Night
Vision" mode selected) and the triggering of
alerts are available.
If certain operating conditions (speed or
temperature) are not met, the
indicator lamp comes on in orange: only the
display in the instrument panel is available (in
"Night Vision" mode).
screen menu.
Switching on / off
This system operates from a certain angle of
rotation of the steering wheel.
The system does not operate:
– below a certain angle of rotation of the
steering wheel.
Night Vision is a driving aid system that
cannot, under any circumstances,
replace the personal assessment of
night-time visibility and traffic conditions. .
In some conditions, the contrasts in
temperature are insufficient and the system
may not detect all dangers or, conversely,
it may give false warnings (e.g. engines of
lorries parked on the edge of the road).
– above 56 mph (90 km/h),
– when reverse gear is engaged.
Whilst the exterior light is too bright or the dipped
beam headlamps have not been switched on,
the alerts are not available.
Night Vision
Activation/Deactivation
This function is set via the Driving/
Vehicle touch screen menu.
Conditions for operation
– With the engine running and in Stop mode
of Stop & Start.
– Very low light conditions with dipped beam
headlamps on and in good working order.
– Temperature between -30°C and +28°C.
– Speed below 99 mph (160 km/h).
– Detection of animals taller than 0.50 m.
This system identifies and signals the presence
of pedestrians and animals in the driver's field
of vision, in low exterior light conditions, using
an infrared camera located at the front of the
vehicle.
Operation
Select the "Night vision" display mode for
the infrared camera image to be displayed
constantly on the instrument panel. When the
If the function is selected but the display
on the instrument panel and the alerts are
79
