Deutsch
EnglishInterior equipment -> Cargo area cover for your Subaru Forester 2019-2024
Cargo area cover
292
6-13. Cargo area cover (if
equipped)
WARNING
Do not place anything on the ex-
tended cover. Putting excessive
weight on the extended cover can
break it and an object on the cover
could tumble forward in the event of
a sudden stop or collision. This
could cause serious injury.
The cargo area cover is provided for
covering the cargo area and to protect its
contents from direct sunlight. This cover is
detachable to make room for additional
cargo.
& Using the cover
CAUTION
Be careful not to scratch the rear
gate stays while extending and re-
winding the cover. Scratches on the
stays could cause leakage of gas
from the stays, which may result in
their inability to hold the rear gate
open.
A convenience hook is attached to the rear
gate trim. When the rear gate is open, you
can hang a lantern, wet suit, etc. on the
hook.
To extend the cover, pull the end of the
cover out of the housing, then insert its
hooks into the catches as shown. To
rewind it, unhook it from the catches and
it will rewind automatically. You should
hold on to the cover and guide it back into
the cover housing while it is rewinding.
Cargo area cover 293
& To install the front part of the & To remove the front cover
& Stowage of the cargo area
cover
cover
1. Push the front cover to the right side
The cargo area cover can be stowed in
under the cargo floor.
and shorten the bar.
2. Remove the front cover.
CAUTION
For models with a reclining rear
& To remove the cover housing
1. Rewind the cover.
seatback, when reclining, move the
front part of the cover back so that it
is not damaged.
1. Pull the strap to open the center part of
the cargo floor lid, and then remove the
lid.
2. Remove the left and right parts of the
cargo floor lid.
2. Push the cover housing to the right
side and shorten it.
1. Align the right side of the front cover
with the triangle mark before fixing the
cover in place.
3. Take it off the retainer.
2. Align the left side of the front cover with
the triangle mark before fixing the
cover in place.
3. Push the front cover to the right side
and adjust the size of the bar as
necessary.
– CONTINUED –
Cargo area cover
294
& To install the cover housing
3. Stow the cover housing in the cargo
area end.
2. Push the cover housing to the right
side and shorten the bar.
3. Insert the other protrusion into the
recess of the other retainer.
1. Insert the protrusion located on the
right end of the sleeve into the recess
of the retainer.
