Deutsch
EnglishStarting and driving -> Compass for your Volvo XC60 2017-2026
STARTING AND DRIVING
||
868.70MHz-868.20MHz <25mW E.R.P.
869.40MHz-869.65MHz <25mW E.R.P.
869.70MHz-870.00MHz <25mW E.R.P.
•
•
•
Activating and deactivating the
Compass*
An integrated compass30 in the upper right
corner of the rearview mirror shows the
direction the vehicle is traveling.
compass*
An integrated compass31 in the upper right
corner of the rearview mirror shows the
direction the vehicle is traveling.
Certificate holder address: Gentex Corpora-
tion, 600 North Centennial Street, Zeeland MI
49464, USA
The compass is automatically activated when
the vehicle is started.
For further details, search for support informa-
To deactivate/activate the compass manually:
–
Use a paper clip or similar object to press
the button on the bottom of the mirror.
Related information
•
HomeLink®* (p. 442)
> If the compass is deactivated when the
vehicle is switched off, it will not be
activated the next time the vehicle is
started. The compass will then need to
be activated manually.
Rearview mirror with compass.
Related information
Eight different compass directions are shown
with the abbreviations: N (north), NE (north-
east), E (east), SE (southeast), S (south), SW
(southwest), W (west) and NW (northwest).
•
•
Related information
•
•
30
31
Rearview mirror with compass is available as an option only on certain markets and models.
Rearview mirror with compass is available as an option only on certain markets and models.
446
* Option/accessory.
STARTING AND DRIVING
7.
Vehicles with heated windshields*: If C
is shown in the display when the wind-
shield heating function is activated, per-
form step 6 above with the heating func-
tion on.
Calibrating the compass*
1
2
The globe is divided into 15 magnetic zones.
The compass32 should be calibrated if the
vehicle is driven from one zone to another.
15
14
3
1. Stop the vehicle in a large, open area away
from steel constructions and high-voltage
power lines.
13
8. Repeat the above procedure as needed.
4
12
Related information
•
5
8
2. Start the engine and switch off all electri-
cal equipment (climate system, wipers,
etc.) and make sure all doors are closed.
11
9
10
•
6
7
Magnetic zones.
4. Press the button on the underside of the
mirror repeatedly until the desired mag-
netic zone (1–15) appears (see the map of
magnetic zones).
Calibration may fail or not even be initiated
if electrical equipment is not turned off.
3. Hold the button on the bottom of the rear-
view mirror pressed for about 3 seconds
(using e.g. a paper clip). The number of the
current magnetic zone is shown.
5.
Wait until the display again shows C, or
press and hold the button on the under-
side of the rearview mirror for approx.
6 seconds until C is displayed.
6. Drive slowly in a circle at a speed of no
more than 10 km/h (6 mph) until a com-
pass direction is shown in the display. This
indicates that calibration is complete.
Drive in a circle two more times to fine-
tune the calibration.
32
Rearview mirror with compass is available as an option only on certain markets and models.
* Option/accessory. 447
AUDIO, MEDIA AND INTERNET
