Engine oil -> Electronic oil measurement for your BMW 6 Series 2011-2017

Engine oil  
Mobility  
Engine oil  
If the engine oil level reaches the minimum  
level, a check control message is displayed.  
Vehicle features and options  
This chapter describes all standard, country-  
specific and optional features offered with the  
series. It also describes features that are not  
necessarily available in your car, e. g., due to  
the selected options or country versions. This  
also applies to safety-related functions and  
systems. The respectively applicable country  
provisions must be observed when using the  
respective features and systems.  
Requirements  
A current measured value is available after ap‐  
prox. 30 minutes of driving. During a shorter  
trip, the status of the last, sufficiently long trip  
is displayed.  
With frequent short-distance trips, regularly  
perform a detailed measurement.  
Displaying the engine oil level  
On the Control Display:  
General information  
1. "Vehicle info"  
The engine oil consumption is dependent on  
the driving style and driving conditions.  
2. "Vehicle status"  
The engine oil consumption can increase in  
case of, for example:  
3.  
"Engine oil level"  
Engine oil level display messages  
Sporty driving.  
Different messages appear on the display de‐  
pending on the engine oil level. Pay attention  
to these messages.  
Break-in the engine.  
Idling of the engine.  
Usage of non-approved engine oil grades.  
If the engine oil level is too low, within the next  
125 miles/200 km Add engine oil, refer to  
page 216.  
Therefore, regularly check the engine oil level  
after refueling.  
The vehicle is equipped with electronic oil  
measurement.  
Engine oil level too low  
Add engine oil immediately; otherwise,  
an insufficient amount of engine oil could re‐  
sult in engine damage.◀  
The electronic oil measurement has two meas‐  
uring principles:  
Status display  
Take care not to add too much engine oil.  
Too much engine oil  
Detailed measurement  
Have the vehicle checked immediately;  
otherwise, surplus engine oil can lead to en‐  
gine damage.◀  
Electronic oil measurement  
Status display  
The concept  
The engine oil level is monitored electronically  
while driving and shown on the Control Dis‐  
play.  
215  
 
Mobility  
Engine oil  
Detailed measurement  
The concept  
Oil filler neck  
In the detailed measurement the engine oil  
level is checked and displayed via a scale.  
Gasoline engine:  
If the engine oil level reaches the minimum  
level, a check control message is displayed.  
Diesel engine:  
During the measurement, the idle speed is in‐  
creased somewhat.  
Only add engine oil when the message is dis‐  
played in the instrument cluster. The quantity  
to be added is indicated in the message dis‐  
played in the instrument cluster.  
General information  
A detailed measurement is only possible with  
certain engines.  
Adding engine oil  
Add oil within the next 125 miles/200 km;  
otherwise, this may cause engine damage.◀  
Requirements  
Vehicle is on level road.  
Do not add too much engine oil  
Steptronic transmission: selector lever in  
selector lever position N or P and accelera‐  
tor pedal not depressed.  
When too much engine oil is added, im‐  
mediately have the vehicle checked, otherwise,  
this may cause engine damage.◀  
Engine is running and is at operating tem‐  
perature.  
Protect children  
Keep oil, grease, etc., out of reach of chil‐  
dren and observe the warnings on the contain‐  
ers to prevent health risks.◀  
Performing a detailed measurement  
In order to perform a detailed measurement of  
the engine oil level:  
1. "Vehicle info"  
Engine oil types to add  
2. "Vehicle status"  
3.  
"Measure engine oil level"  
Hints  
4. "Start measurement"  
No oil additives  
The engine oil level is checked and displayed  
via a scale.  
Oil additives may lead to engine dam‐  
age.◀  
Time: approx. 1 minute.  
Viscosity grades for engine oils  
When selecting an engine oil, ensure that  
the engine oil belongs to one of the viscosity  
grades SAE 0W-40, SAE 0W-30, SAE 5W-40,  
and SAE 5W-30 or malfunctions or engine  
damage may occur.◀  
Adding engine oil  
General information  
Switch off the ignition and safely park the vehi‐  
cle before engine oil is added.  
216