Deutsch
EnglishTechnical Information -> Identification Numbers for your Honda CR-V 2006-2010
09/07/16 18:55:40 31SWA630_410
Technical Information
The diagrams in this section give
you the dimensions and capacities of
your vehicle and the locations of the
identification numbers. It also
includes information you should
know about your vehicle’s tires and
emissions control systems.
Identification Numbers................. 406
Specifications ................................. 408
DOT Tire Quality Grading
(U.S. Vehicles)........................... 410
Tire Labeling.................................. 412
Tire Pressure Monitoring System
(TPMS) － Required Federal
Explanation............................. 414
Emissions Controls........................ 416
Three Way Catalytic Converter... 418
Emissions Testing ......................... 419
405
09/07/16 18:55:47 31SWA630_411
Identification Numbers
Your vehicle has several identifying
numbers located in various places.
VEHICLE IDENTIFICATION NUMBER (VIN)
The vehicle identification number
(VIN) is the 17-digit number your
dealer uses to register your vehicle
for warranty purposes. It is also
necessary for licensing and insuring
your vehicle. The easiest place to
find the VIN is on a plate fastened to
the top of the dashboard. You can
see it by looking through the
windshield on the driver’s side. It is
also on the certification label
attached to the driver’s doorjamb,
and is stamped on the engine
compartment bulkhead. The VIN is
also provided in bar code on the
certification label.
To access the VIN in the engine
compartment, pull down the lid on
the back of the engine compartment.
Make sure to close the lid before
closing the hood.
CERTIFICATION LABEL
406
09/07/16 18:55:51 31SWA630_412
Identification Numbers
The engine number is stamped into
the front of the engine block.
AUTOMATIC TRANSMISSION
You can see the engine number
through the window next to the ‘‘H’’
logo.
The transmission number is on a
label on top of the transmission.
ENGINE NUMBER
407
09/07/16 18:56:11 31SWA630_413
Specifications
Dimensions
Length
Width
Height
Wheelbase
Capacities
Engine
coolant
Automatic
transmission
fluid
179.3 in (4,555 mm)
71.6 in (1,820 mm)
66.1 in (1,680 mm)
103.1 in (2,620 mm)
61.6 in (1,565 mm)
61.6 in (1,565 mm)
Change＊2
Total
Change
4WD
2WD
Total
1.56 US gal (5.9
1.85 US gal (7.0
)
)
2.6 US qt (2.5
2.6 US qt (2.5
)
)
Track
Front
Rear
4WD
7.4 US qt (7.0
)
Weights
2WD
6.71 US qt (6.35
)
Gross vehicle weight rating
See the certification label attached
to the driver’s doorjamb.
Rear
Change
Total
1.3 US qt (1.2
1.5 US qt (1.4
)
)
differential
fluid (4WD)
Windshield
washer
Engine
Type
U.S. Vehicles
Canadian
Vehicles
2.6 US qt (2.5
4.8 US qt (4.5
)
)
Water cooled 4-stroke DOHC
i-VTEC 4-cylinder gasoline engine
3.43 x 3.90 in (87.0 x 99.0 mm)
144 cu-in (2,354 cm )
reservoir
Bore x Stroke
Displacement
Compression ratio
Spark plugs
＊1 : Excluding the oil remaining in the engine
＊2 : Including the coolant in the reserve tank and that remaining in the
10.5 : 1
ILZKR7B-11S (NGK)
engine
SXU22HCR11S (DENSO)
Reserve tank capacity:
0.16 US gal (0.6
)
Capacities
Fuel tank
Approx.
15.3 US gal (58
)
Engine oil
Change＊1
Including filter 4.4 US qt (4.2
Without filter
Total
)
)
)
4.2 US qt (4.0
5.6 US qt (5.3
408
09/07/16 18:56:32 31SWA630_414
Specifications
Seating Capacities
Battery
Total
Front
Rear
5
2
3
Capacity
12 V － 36 AH/5 HR
12 V － 38 AH/5 HR
12 V － 45 AH/20 HR
12 V － 47 AH/20 HR
Air Conditioning
Refrigerant type
Charge quantity
Lubricant type
HFC-134a (R-134a)
15.5－17.3 oz (440－490 g)
SP-10
Fuses
Interior
See page 401 or the fuse label
attached under the steering
column.
Lights
Headlights
Under-hood
See page 402 or the fuse box
cover.
High/Low
60/55 W (HB2)
21 W (Amber)
3 CP
Front turn signal lights
Parking lights/side marker
lights
Rear turn signal lights
Stop/Taillights
Back-up lights
Taillight/Rear side marker
lights
Alignment
Toe-in
Front
Rear
Front
Rear
Front
0.0 in (0 mm)
0.08 in (2.0 mm)
0°
21 W (Amber)
21/5 W
21 W
Camber
Caster
－1°00’
2°44’
5 W
High-mount brake light
License plate light
Ceiling light
21 W
5 W
8 W
8 W
8 W
2 W
Tires
Size
Front/Rear
Spare
225/65R17 102T
T155/90D17 101M
T155/90R17 101M
Spotlights
Cargo area light
Pressure
Front
Rear
Spare
30 psi (210 kPa , 2.1 kgf/cm )
30 psi (210 kPa , 2.1 kgf/cm )
60 psi (420 kPa , 4.2 kgf/cm )
Vanity mirror Lights＊
＊ : EX, EX-L
409
09/07/16 18:56:42 31SWA630_415
DOT Tire Quality Grading (U.S. Vehicles)
The tires on your vehicle meet all
U.S. Federal Safety Requirements.
All tires are also graded for
Treadwear
Traction
The treadwear grade is a compara-
tive rating based on the wear rate of
The traction grades, from highest to
lowest, are AA, A, B, and C. Those
treadwear, traction, and temperature
performance according to
the tire when tested under controlled grades represent the tire’s ability to
conditions on a specified government stop on wet pavement as measured
test course. For example, a tire
Department of Transportation
(DOT) standards. The following
explains these gradings.
under controlled conditions on
specified government test surfaces
of asphalt and concrete. A tire
marked C may have poor traction
performance.
graded 150 would wear one and one-
half (1 1/2) times as well on the
government course as a tire graded
100. The relative performance of
tires depends upon the actual condi-
tions of their use, however, and may
depart significantly from the norm
due to variations in driving habits,
service practices and differences in
road characteristics and climate.
Uniform Tire Quality Grading
Quality grades can be found where
applicable on the tire sidewall
between tread shoulder and
maximum section width. For
example:
Warning: The traction grade
assigned to this tire is based on
straight-ahead braking traction tests,
and does not include acceleration,
cornering, hydroplaning, or peak
traction characteristics.
Treadwear 200
Traction AA
Temperature A
All passenger car tires must conform
to Federal Safety Requirements in
addition to these grades.
410
09/07/16 18:56:47 31SWA630_416
DOT Tire Quality Grading (U.S. Vehicles)
Temperature
Warning: The temperature grade for
The temperature grades are A (the
highest), B, and C, representing the
tire’s resistance to the generation of
heat and its ability to dissipate heat
when tested under controlled
this tire is established for a tire that
is properly inflated and not
overloaded. Excessive speed,
underinflation, or excessive loading,
either separately or in combination,
can cause heat buildup and possible
tire failure.
conditions on a specified indoor
laboratory test wheel. Sustained high
temperature can cause the material
of the tire to degenerate and reduce
tire life, and excessive temperature
can lead to sudden tire failure. The
grade C corresponds to a level of
performance which all passenger car
tires must meet under the Federal
Motor Vehicle Safety Standard No.
109. Grades B and A represent
higher levels of performance on the
laboratory test wheel than the
minimum required by law.
411
09/07/16 18:56:59 31SWA630_417
Tire Labeling
The tires that came on your vehicle
have a number of markings. Those
Tire Size
102 － Load index (a numerical code
associated with the maximum
load the tire can carry).
Whenever tires are replaced, they
you should be aware of are described should be replaced with tires of the
below.
same size. Below is an example of
tire size with an explanation of what
each component means.
T
－ Speed symbol (an
TIRE LABELING EXAMPLE
(1)
alphabetical code indicating
the maximum speed rating).
225/65R17 102T
Tire Identification Number (TIN)
The tire identification number (TIN)
is a group of numbers and letters
that look like the following example.
TIN is located on the sidewall of the
tire.
225 － Tire width in millimeters.
65 － Aspect ratio (the tire’s section
height as a percentage of its
width).
R
－ Tire construction code (R
DOT B97R FW6X 2202
indicates radial).
DOT － This indicates that the tire
meets all requirements of
the U.S. Department of
Transportation.
(1)
17 － Rim diameter in inches.
(4)
(3)
(2)
(1) Tire Size
B97R － Manufacturer’s
(2) Tire Identification Number (TIN)
(3) Maximum Tire Pressure
(4) Maximum Tire Load
identification mark.
412
